Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterMr-Glass Roof Replacement & Installation in Davie: What to Know First
We replace and install Mr-Glass roof products for homeowners throughout Davie, and most jobs are completed within one to three business days once parts are in hand. As an independent Mr-Glass service provider, our pricing is straight: you’ll see the full line-item quote before any work begins, and the number we quote is the number you pay. If you own a Davie home with Mr-Glass roof glass, skylights, or structural panels that are leaking, fogged, or cracked, call (863) 208-5172 and a live person will answer.
This page is written for Mr-Glass owners in Davie who need honest answers about what fails, why it fails, and what a proper repair or replacement should cost. We don’t sell Mr-Glass products and we aren’t a Mr-Glass dealer. What we do is fix them correctly, warranty the work in writing, and stand behind it.
Key Takeaways
- Independent Mr-Glass roof replacement and installation serving Davie and Broward County
- Dale Kessler and our technicians have measured, set, and sealed roof glass in Davie for over 26 years
- Both warranty layers registered in writing before the truck leaves your driveway
- Done Right Promise on every job, no paperwork fights
- Free estimates, line-item quotes in writing, no surprise charges
How Mr-Glass Products Fail - and How We Fix Them
Roof glass in Davie gets no mercy. Between the summer thunderstorm season, the salt air that drifts in from the coast, and the flat-angle sun that beats on a skylight or roof panel all afternoon, a Mr-Glass unit that was marginally installed will show its weakness within a few years. Here are the failure patterns we see on Mr-Glass jobs in Davie neighborhoods like Shenandoah, Forest Ridge, and Hawkes Bluff, and what we do about them.
- Mr-Glass skylight seal failure at the curb mount. The rubber and butyl seals Mr-Glass used on many curb-mounted skylight units break down faster in Davie’s UV load than in cooler climates. The first sign is usually a brown stain on the ceiling drywall after a heavy summer downpour, not a visible drip. The water travels sideways along the roof deck before it finds a seam. We strip the old sealant, inspect the curb for rot, rebuild if needed, and reset the unit with a marine-grade sealant rated for Florida roof temperatures.
- Mr-Glass roof panel glazing gasket shrinkage. On older Mr-Glass structural roof systems, the EPDM gaskets that hold the glass in the frame shrink and crack after fifteen to twenty years of Davie heat. Owners notice a rattle in high wind or a small water line on the inside of the frame after a storm. We replace the gaskets with current-spec material and re-torque the pressure plates to the manufacturer’s pattern. If the frame is too far gone, we tell you honestly and quote a panel replacement instead of patching something that will fail again.
- Interior fog between Mr-Glass insulated glass layers. Once a Mr-Glass double-pane roof unit loses its edge seal, the argon or krypton fill leaks out and Florida humidity gets pulled in. The fog is permanent; there is no cleaning it. We measure the existing unit precisely, order a replacement insulated glass unit with the correct low-e coating and fill for a South Florida pitch, and swap it into the existing frame when the frame is still sound. You keep the original look without paying for a full frame teardown.
- Mr-Glass flashing failures on roof-integrated panels. Many Davie homes with Mr-Glass roof glass have the panels flashed into tile or shingle roofs with metal that was sized poorly from the start. Over time, expansion and contraction works the flashing loose at the corners. We see this most often on homes in western Davie where afternoon temperatures sit higher and the roof deck moves more. We remove the old flashing, install properly overlapped step flashing, and re-bed the pan corners so water sheds away from the opening instead of pooling against it.
- Improperly pitched Mr-Glass roof panels holding water. A roof glass panel that doesn’t drain will fail no matter how well it’s sealed. On flat and low-slope Davie roofs, we see Mr-Glass units set at less than the minimum pitch, which lets water sit against the lower gasket. That standing water softens the seal and eventually works its way inside. The fix isn’t always a full re-pitch, but it often is. We’ll tell you if a simple re-glaze will hold or if the opening needs to be rebuilt to correct the slope. We won’t quote a patch on a panel that needs a proper fix.
Our Mr-Glass Roof Replacement & Installation Process
When you call about a Mr-Glass roof problem in Davie, here is how the job goes from the first phone call to cleanup.
- 1
You call, a real person answers. You describe what you’re seeing. We ask the right questions: when the leak appears, what the unit looks like from inside, whether the glass is cracked or just fogged. We schedule a time that works for you and show up in a uniformed truck.
- 2
We inspect the roof opening, inside and out. Our technician gets on the roof and looks at the seal, the flashing, the pitch, and the frame condition. Inside, we check the drywall, the interior frame, and the glass for seal failure. If your Mr-Glass unit is leaking, we find out where the water is really coming from, because it’s often not where the stain shows.
- 3
We put your options on paper. If the frame is sound and the glass can be swapped, we quote the glass-only replacement. If the frame, flashing, or curb needs work, we quote the full scope. We don’t guess, and we don’t hide costs in a vague line item. If the structure is too far gone to save, we say so and explain exactly why.
- 4
We source the right parts. For Mr-Glass jobs, we evaluate whether an OEM replacement glass unit is available or whether a high-quality aftermarket insulated unit will perform better for a Davie roof. We will not install a unit with a coating or fill grade that doesn’t match the heat load of a South Florida roof.
- 5
We do the work and test it. The old unit comes out cleanly. The new one goes in level, shimmed correctly, sealed with the right materials, and flashed so water sheds properly. We run a water test on the opening before we leave the roof.
- 6
We register the warranties and hand you the paperwork. Before the truck leaves your driveway, both manufacturer warranty layers are registered in writing with the durations stated. We stand behind our workmanship for 90 days. Done right, on the first visit.
What Mr-Glass Roof Replacement & Installation Costs in Davie
Roof glass replacement in Davie runs from roughly $800 to $4,500, depending on what is actually happening. A fogged Mr-Glass skylight with a good frame might be $800 to $1,400 for a new insulated glass unit installed. A full skylight replacement with curb rebuild and new flashing often lands between $1,600 and $3,200. A larger roof glass panel or structural roof system replacement can reach $4,500 or more when the framing, flashing, and structural support need rebuilding.
- Mr-Glass skylight insulated glass unit replacement: $800 - $1,400
- Full Mr-Glass skylight replacement with curb rebuild: $1,600 - $3,200
- Mr-Glass roof panel re-glaze with new gaskets and seal: $1,200 - $2,800
- Complete Mr-Glass roof panel replacement with flashing rebuild: $2,800 - $4,500+
- Rotted curb or decking repair (if needed): quoted separately, line by line
The price moves based on glass size, low-e coating spec, roof pitch, accessibility, and whether the frame is sound. We don’t pad quotes and we don’t hand you a “range” that somehow becomes the high number at billing. Call (863) 208-5172 and we’ll schedule a time to look at your roof, give you a written line-item estimate, and tell you what it will take to fix it right.
Why Davie Homeowners Call TruePane Windows & Doors for Mr-Glass Work
Calling a generalist roofer for a Mr-Glass roof unit is a gamble. Roofers know shingles and tile, not the glass edge seals, gasket tolerances, and thermal movement that decide whether a Mr-Glass unit survives the next Davie summer. We do. Dale Kessler grew up off Orange Drive near the old Davie Arena, trained at McFatter Technical College, and has been setting and sealing glass in Broward County for over 26 years. Our technicians know what a Mr-Glass frame looks like when it’s failing from the inside out, and they know what sealant holds up in this climate. If a Mr-Glass unit can’t be saved and a full replacement makes more sense, we can quote PGT, CGI, CWS, or ES Windows alternatives side by side so you see the difference in writing. No pressure, no upsell. If the pane is not true, the job is not done, and we don’t leave until it is.
Every Mr-Glass job in Davie is covered by our Done Right Promise and The Keystone Standard: both manufacturer warranty layers registered in writing, durations stated, before the truck leaves. We’ve served this community since 2008, and we plan to be here in thirty more. We answer the phone, we show up on time, and we stand behind the work. A square deal, every time.
FAQs
No. We are an independent Mr-Glass service provider. We repair and replace Mr-Glass roof glass, skylights, and structural panels, but we are not a Mr-Glass dealer and we never imply otherwise. Our independence means we recommend what is right for your Davie roof, not what a manufacturer’s program pushes. Call (863) 208-5172 for an honest assessment.
If your Mr-Glass product is still under its original warranty, a repair by an independent contractor can potentially affect warranty coverage, depending on the terms. We are upfront about this before any work begins. What we can tell you is that a failed seal or leaking roof unit in Davie is already not performing its function, and leaving it alone costs more in water damage than the warranty is worth. We’ll walk you through what to ask Mr-Glass and what the practical options are. Call (863) 208-5172 and we’ll talk it through.
Often just the glass can be swapped. If the Mr-Glass frame is still square, dry, and structurally sound, we can order a replacement insulated glass unit and install it in the existing frame for far less than a full replacement. If the frame is rotted, cracked, or out of square, we’ll tell you and quote the full job. We never push a full replacement when a glass swap will do. Call (863) 208-5172 to schedule a look.
Most roof glass replacement jobs are completed in one day once the glass or unit arrives. Custom sized insulated glass units typically take one to two weeks to fabricate, and we schedule your roof work on a clear-weather day. The actual installation, from removing the old unit to final cleanup, is usually four to six hours. We’ll give you a firm timeline when we quote the job. Call (863) 208-5172 for scheduling.
Our workmanship is guaranteed for 90 days under the Done Right Promise. If the repair we made fails during that window, we come back and make it right, no arguing and no paperwork fights. Beyond that, the manufacturer warranty layers we registered in writing on the new glass or unit cover defects in the materials themselves. We stand behind what we do. If it is not right on paper, it will not be right in the wall. Call (863) 208-5172 if you have any question after the job.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Davie and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.